WiFiScope WS6 1 GSa/s 14 bit quad channel High Resolution WiFi Oscilloscope

WiFi connected

Using a computer based oscilloscope was never easier than with the WiFiScope WS6: simply switch it on and start the software on the computer:

• no power cables required as it is battery powered and can operate hours on a fully charged battery
• no interface cables required as it uses WiFi to connect to the computer

This allows you to measure fully floating, fully isolated from your computer. The WiFiScope WS6 can be placed near any test subject that may be hard to reach, or on moving objects, where wired connections are not possible.

Because the WiFiScope WS6 is not connected to the computer, there is no risk of damaging the computer.

LAN connected

When measuring in remote locations where a wired network is available, the WiFiScope WS6 can also be used through its LAN port. Measurements can then be performed from any location via the network, without having the computer to be close to the test subject.

Using its 1 Gbit LAN connection, the WiFiScope WS6 can achieve higher streaming performance than via WiFi.

USB 3.0 connected

When wireless measuring or LAN connected measuring is not required or not possible, the WiFiScope WS6 can also be connected via its USB3 port. This gives the benefit of even higher streaming performance. Additionally, when connected via USB, the WiFiScope WS6 can be combined with oscilloscopes via its CMI interface.

Key specifications

• 8, 12, 14, 16 bit resolution, 0.25 % DC vertical accuracy, 0.1 % typical
• Up to 1 GSa/s sampling, up to 250 MHz bandwidth
• Up to 256 MSamples memory per channel
• Up to 200 MSs/s continuous streaming
• 1 ppm time base accuracy

[ Datasheet ]